You must also use a piece of software called the PG/PC Interface (inside Step 7) to enable the MPI driver for the adapter or processor, and to diagnose the connection.ĭon't hesitate to come back to us for more details, if required. A CP 5711 is often recommended: 6GK1571-1AA00, USB to MPI/Profibus adapter. If you fail with any step I would recommend uninstall Step7, clean disk and register and try to install again. Check interface configuration: Set PG/PC Interface>PC Adapter (select Auto or desired protocol)>Properties>Local Connection>Connection to:COM (your port number). The PLC side requires Step 7 v5.6 (as you work with Windows 10).Ĭhapter 19 of the Programming with Step 7 manual describes downloading and upploading procedures for S7-300 and S7-400 PLCs(look at the screenshot below).īefore you can upload from the C7, you must have a correct connection adapter or processor. Re: Request: PC RS232 adapter V5.1 (6ES7972 0CA23 0XA0) driv. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |